They are placed at the beginning and at the end of the line, in front of the electrical substation — they are connected to the portals ОРУ and perceive the one-sided tension of the wires.

| Type of support | Endpoints |
| Designation | K, CS |
| Voltage classes | 220 kV · 330 kV · 500 kV |
| Design | Lattice, from plate and angle sections |
| Material | Steel 09G2S-12 / S345-3 or St3ps5 / S245, S255 |
| Corrosion protection | Hot-dip galvanising to GOST 9.307-21 |
| Service life | At least 50–70 years without repainting |
| Manufacturing | To standard type designs or to the customer's structural drawings |
| Scope of supply | Shipping sections and fasteners; pile caps and embedded parts on request |
| Documents | Data sheet, steel certificates and corrosion protection documentation |
The tower weight and dimensions are confirmed when the detail drawings are issued for the wind and ice region of the site.
The end support closes the line: the full weight of the wires acts on it from the highway side, and there is almost no load from the substation side. Such an asymmetrical circuit requires a rigid structure designed for constant unilateral force.
They are indicated by the letters K and KS, followed by the voltage class. They work in tandem with the portals of an open switchgear — from the end support, the busbar enters the portal and then onto the substation equipment.
We manufacture according to standardized standard designs and according to customer drawings. Portals ОРУ, grillings and embedded parts are supplied with the same set — the entire approach to the substation is closed with one specification.
We receive the schedule, questionnaire or structural drawings.
We select the types for the route and climatic region and calculate the cost.
We issue working drawings and manufacture the structures with hot-dip galvanising.
Shipped as sections by road or rail.
At the beginning and at the end of an overhead line, usually in front of an electrical substation. From it, the bus enters the portals of an open switchgear.
The anchor line perceives gravity from two sides and divides the line into anchor sections, the end line — only from one side, because the line ends behind it. The load is constant and asymmetrical, and the structure is stiffer for it.
Yes, this is a standard set: end supports, portals, grillings and embedded parts come with one specification and one shipment.
Our range includes 220, 330 and 500 kV. For other classes, the approach to the substation is solved by anchor-angle supports; we will specify according to your project.
Send the tower schedule or the route parameters — we will select the types and prepare a calculation.
Request a quote